| Dust Removal Fan | Fan Power 5.5kw |
|---|---|
| Coating Layers | 3 Layers |
| Control System | PLC |
| Recycle Of Epoxy | Air Rate 50k M³ |
| Pipe Surface Preparation | Shot Blasting |
| Dust Removal Fan | Fan Power 5.5kw |
|---|---|
| Coating Layers | 3 Layers |
| Control System | PLC |
| Recycle Of Epoxy | Air Rate 50k M³ |
| Pipe Surface Preparation | Shot Blasting |
| Dust Removal Fan | Fan Power 5.5kw |
|---|---|
| Coating Layers | 3 Layers |
| Control System | PLC |
| Recycle Of Epoxy | Air Rate 50k M³ |
| Pipe Surface Preparation | Shot Blasting |
| Heating Method | Induction Heating |
|---|---|
| Temperature | 0-30℃ |
| Coating Type | 3PE, 2PE, Fbe |
| Moisture | 85% No Condensation |
| Extrusion Process | Multi-Layer Extrusion |
| Power Supply | 3 Phase 380V(-10%,+5%) 50HZ |
|---|---|
| Installed Capacity | About 750 KW |
| Cooling Water Recycling | ≤15℃,0.15-0.2МПа,0.5м³/мин |
| Moisture | 85% No Condensation |
| Extrusion Process | Multi-Layer Extrusion |
| Place | Indoor |
|---|---|
| Power | No Danger Zone |
| Moisture | 85% No Condensation |
| Cooling Water Recycling | ≤15℃,0.15-0.2МПа,0.5м³/мин |
| Extrusion Process | Multi-Layer Extrusion |
| 304 Powder Fluidized Box | Vibrating Screen With Power Recovery |
|---|---|
| Cyclone Dust Collector | Dust Removal Efficiency 90% |
| High Voltage Electrostatic Spray Gun | Ultimate High Pressure 10kV |
| Filter Cartridge Dust Collector | Filter Air Volume 5500 Cubic Meters Per Hour |
| Coating Structure | Epoxy+Adhesive+PE |
| Anticorrosion | Internal &External |
|---|---|
| Thickness | 3.5um-4.0um |
| Electrical Control System | Low Voltage Electrical Delixi |
| Steel Pipe Turning Machine | 3kw |
| PE Beveling Machine | Semi-closed Beveling Machine, Powder Does Not Fall To The Ground |
| Coating Thickness | 1.8-2.7mm |
|---|---|
| Control System | PLC Control |
| Pipe Length | 1-3m |
| Coating Type | 3LPE (Three Layer Polyethylene) |
| Pipe Diameter Range | Φ219-Φ1420mm |
| PE Layer Thickness | 2.5 - 3.7 Mm |
|---|---|
| Ad Copolymer Adhesive Thickness | 170-250 Um |
| Epoxy Powder Thickness | More Than 170 Um |
| Elbow Angle | 15-90 Degrees |
| Surface Treatment | Shotblasting SA2.5 |